Reversing of the engine is performed electronically and controlled by the Engine Control System,by changing the timing of the fuel injection, the exhaust valve activation and the starting valves.
Any opening in a pressure vessel is kept to a minimum and for a man entry an elliptical hole is lesser in size than the corresponding circular hole. More over it is prime concern to have a smoothed generous radius at the corners to eliminate stress concentration. Hence other geometrical shapes like rectangle and square are ruled out. To compensate for the loss of material in the shell due to opening, a doubler ring has to be provided around the opening. The thickness of the ring depends on the axis length along the dirrection in which the stresses are maximum and the thickness of the shell. It is important to align the minor axis along the length of the vessel, as the stress in this direction is maximum. Longitudinal stress: Pd/2t where P= pressure inside the vessel, d= diameter of the arc, t= thickness of the shell plating Circumferential stress: Pd/4t More over a considerable material and weight saving is achieved as minor is along the direction of maximum stress.
Thanks for sharing this amazing post this is the content i really looking for, it's very helpful i hope you will continue your blogging anyway if anyone looking for AutoCAD training institute in delhi contact us +91-9311002620 visit-https://www.htsindia.com/autocad-training-institute
ReplyDelete