1. Loosen The Castle Nut By Suitable Spanner.
2. Take Out The Split Pin.
3. Remove The Nut Washer.
4. Remove Buffer Plate.
5. Remove 3 Spring Plates.
6. Remove Damper Plate.
7. Remove Valve Plate And Guide Washer.
8. Remove Locating Pin(it Keeps The Valve Aligned ).Now All The Plates Are Checked For Proper Seating , If Valve Plate Does'nt Seat Properly, It Is Lapped By A coarser And finer Paste, Making A Figure Of 8 On A True Surface Plate. A Figure Of 8 Is Made Because An Even And Continuous Lapping Can Be Done Only By A Figure Of 8.
2. Take Out The Split Pin.
3. Remove The Nut Washer.
4. Remove Buffer Plate.
5. Remove 3 Spring Plates.
6. Remove Damper Plate.
7. Remove Valve Plate And Guide Washer.
8. Remove Locating Pin(it Keeps The Valve Aligned ).Now All The Plates Are Checked For Proper Seating , If Valve Plate Does'nt Seat Properly, It Is Lapped By A coarser And finer Paste, Making A Figure Of 8 On A True Surface Plate. A Figure Of 8 Is Made Because An Even And Continuous Lapping Can Be Done Only By A Figure Of 8.
Suction and discharge valve diffrence
ReplyDeleteThanks for helping us understand this topic. You have written it in a way that makes it very simple to understand. Thank you so much. Used Lapping Equipment for Sale.
ReplyDeleteI liked the way you wrote the article. It was very straightforward and your knowledge on the subject is fantastic. Glass Lapping and Polishing Services for All Materials.
ReplyDelete