- Check over speed device.
- Check governor
- Check fuel pump rack
- Open crankcase and check the condition inside
- Check bottom end bolts. It is better to change them once over speed trip has taken place.
- Over speed limits for AE-15% and for ME-20%
Any opening in a pressure vessel is kept to a minimum and for a man entry an elliptical hole is lesser in size than the corresponding circular hole. More over it is prime concern to have a smoothed generous radius at the corners to eliminate stress concentration. Hence other geometrical shapes like rectangle and square are ruled out. To compensate for the loss of material in the shell due to opening, a doubler ring has to be provided around the opening. The thickness of the ring depends on the axis length along the dirrection in which the stresses are maximum and the thickness of the shell. It is important to align the minor axis along the length of the vessel, as the stress in this direction is maximum. Longitudinal stress: Pd/2t where P= pressure inside the vessel, d= diameter of the arc, t= thickness of the shell plating Circumferential stress: Pd/4t More over a considerable material and weight saving is achieved as minor is along the direction of maximum stress.