Skip to main content

Maritime TORTS and types

Maritime law torts is a term covering cases where injury, loss or damage is caused to a person or their interests by another party’s action or negligence.
Types of torts 3 types
Intentional torts
An intentional tort is a civil wrong that occurs when the wrongdoer engages in intentional conduct that results in damages to another.
Negligence
Careless conduct that results in damage to another is negligence
Strict liability
Generally, liability because of a tort only arises where the defendant either intended to cause harm to the plaintiff or in situations where the defendant is negligent.  However, in some areas, liability can arise even when there is no intention to cause harm or negligence.
For example, in most states, when a contractor uses dynamite  which causes debris to be thrown onto the land of another and damages the landowner’s house, the landowner

Comments

Popular posts from this blog

Why is a man hole door elliptical in shape?

Any opening in a pressure vessel is kept to a minimum and for a man entry an elliptical hole  is lesser in size than the corresponding circular hole. More over it is prime concern to have a  smoothed generous radius at the corners to eliminate stress concentration. Hence other  geometrical shapes like rectangle and square are ruled out.  To compensate for the loss of material in the shell due to opening, a doubler ring has to be  provided around the opening. The thickness of the ring depends on the axis length along the  dirrection in which the stresses are maximum and the thickness of the shell. It is important to  align the minor axis along the length of the vessel, as the stress in this direction is  maximum. Longitudinal stress: Pd/2t where P= pressure inside the vessel, d= diameter of the arc, t=  thickness of the shell plating  Circumferential stress: Pd/4t  More over a considerable material and weight saving is achieved as minor is along the  direction of maximum stress.

Shell Expansion Plan

It is a two dimensional drawing of a three dimensional surface of the ship’s hull form. This plan is very useful for the following information:It is used for marking the location of a hull Damage on this plan by identifying the strake number , letter and frame number so that the exact location of the damage and also suggested repairs are marked in a localised copy. The shell expansion can be used for finding areas of painting surfaces such as topside, boot topping and bottom areas by applying Simpsons rules directly.  In the shell expansion the vertical scale used is different from the horizontal scale and a suitable adjustment has to be made when calculating areas. This becomes useful in solving disputes concerning areas of preparation and painting. It gives information on the thickness of the original strake which is indicated by the number in the circle shown in the strake.  The quality of steel used is also shown by letters A,B,D E and AH, BH,DH, EH.