What is the routine anchor windlass maintenance?

a. Brake drum should be free of oil, grease and other deposits. The brake drum should
be cleaned periodically with a solvent prescribed by the maker
b. The brake drum and the disk should be checked for wearing out or damage
c. Gear oil should be checked for contaminants and level
d. The direction of tensioning should correspond to the correct operation of the brake. As
the reverse direction for tensioning would render the brake ineffective, check should
be carried out to ensure the same
e. Brake test of the windlass is to be carried out to the pressure mentioned by the
maker on the jack tool. If necessary, the spring tension adjusted. It should be done in
guidance of the instructions and in the tensioning direction. The number of turns on
the drum should also be checked and should be same as to the makers quote
f. The securing device of the tension spring adjust should be checked periodically for
any tamper
g. Anchor windlass testing should be carried out to check the efficiency of the windlass.
The windlass should raise the anchor with chain from 82.5m to 27.5m at a mean
speed of 9m/min
h. The foundation of the windlass should be checked
i. Other routines of the prime mover should also be carried out like for the windlass
electric motor or the hydraulic motor as the case may be

Comments

Manganese bronze is not typically used as a propeller material .Why

1. High cost: Manganese bronze is a costly alloy, making it less economical for large propellers. 2. Low strength-to-weight ratio: Compared to other propeller materials like nickel-aluminum bronze or stainless steel, manganese bronze has a lower strength-to-weight ratio. 3. Susceptible to corrosion: Manganese bronze can corrode in seawater, especially when exposed to high velocities and turbulence. 4. Poor cavitation resistance: Manganese bronze is more prone to cavitation damage than other materials. 5. Difficult to cast and machine: Manganese bronze is challenging to cast and machine, making it less desirable for complex propeller geometries. 6. Limited weldability: Manganese bronze has poor weldability, making repairs and modifications difficult. Nickel-aluminum bronze or stainless steel are commonly used for propellers due to their: - High strength and durability - Excellent corrosion resistance - Good cavitation resistance - Ease of casting and machining - Weldability

MAN B&W MC Engine VIT Pump

The pump is basically a jerk type with a plunger moving in a matched barrel, using two helical grooves machined in the plunger to control the end of injection by uncovering spill ports and causing the discharge pressure to drop rapidly, thus causing the needle valve in the injector to close. Oil is supplied to the barrel via the spill ports and a suction valve. The suction valve, situated at the top of the barrel opens when the pressure in the barrel falls below the supply pump pressure; i.e. during downward stroke of plunger, while spill ports are covered by plunger. Replaceable erosion plugs are fitted in the pump housing opposite the spill ports. The high pressure oil, spilling back, as the edge of the helix uncovers the s...

Main engine interlocks

Interlocks are provided so that the engine can be started or reversed only when certain conditions have been fulfilled. When there is a remote control of engines, it is essential to have interlocks. This reduces the possibility of engine damage and any hazards to the operating personnel. Turning gear Interlock . This device prevents the engine from being started if the Turning gear is engaged. Running Direction Interlock . This prevents the fuel from being supplied if the running direction of the engine does not match the Telegraph. Starting Air Distributor in end position . This prevents starting from taking place if the shifting of the Distributor has not been completed. Main Lube. oil pressure, Piston cooling pressure, Jacket water pressure, and important parameters must be above the required minimum. Auxiliary Blower Interlock . The Auxiliary Blower is provided in case of Constant pressure turbo charging. Air Spring pressure Interlock . In case of the present generation...

MEOclassIIexamnotes

Search This Blog